Browse over 10,000 Electronics Projects

Macbook Charger Teardown: The surprising complexity inside Apple’s power adapter

Macbook Charger Teardown: The surprising complexity inside Apple’s power adapter

[tps_header][/tps_header]

Have you ever wondered what’s inside your Macbook’s charger?

There’s a lot more circuitry crammed into the compact power adapter than you’d expect, including a microprocessor.

In this charger teardown article, Ken Shirriff looks at the numerous components in the charger and explains how they work together to power your laptop.

Inside the Macbook charger, after removing the heat sinks and insulating tape.

Inside the Macbook charger. Many electronic components work together to provide smooth power to your laptop.

Most consumer electronics, from your cell phone to your television, use a switching power supply to convert AC power from the wall to the low-voltage DC used by electronic circuits.
The switching power supply gets its name because it switches power on and off thousands of times a second, which turns out to be a very efficient way to do this conversion.[1]



Advertisement1


Switching power supplies are now very cheap, but this wasn’t always the case.
In the 1950s, switching power supplies were complex and expensive, used in aerospace and satellite applications that needed small, lightweight power supplies.
By the early 1970s, new high-voltage transistors and other technology improvements made switching power supplies much cheaper and they became widely
used in computers.[2]
The introduction of a single-chip power supply controller in 1976 made switching power supplies simpler, smaller, and cheaper.

Apple’s involvement with switching power supplies goes back to 1977 when Apple’s chief engineer Rod Holt designed a switching power supply for the Apple II.
According to Steve Jobs:[3]

“That switching power supply was as revolutionary as the Apple II logic board was. Rod doesn’t get a lot of credit for this in the history books but he should. Every computer now uses switching power supplies, and they all rip off Rod Holt’s design.”

This is a fantastic quote, but unfortunately it is entirely false.
The switching power supply revolution happened before Apple came along, Apple’s design was similar to earlier power supplies[4]
and other computers don’t use Rod Holt’s design.
Nevertheless, Apple has extensively used switching power supplies and pushes the limits of charger design with their compact, stylish and advanced chargers.

Inside the charger

For the teardown I started with a Macbook 85W power supply, model A1172, which is small enough to hold in your palm. The picture below shows several features that can help distinguish the charger from counterfeits: the Apple logo in the case, the metal (not plastic) ground pin on the right, and the serial number next to the ground pin.

Pages: 1 2 3 4 5 6 7 8

 


Top