Browse over 10,000 Electronics Projects

High Efficiency 12V White LED Driver

High Efficiency 12V White LED Driver

It runs 8 white LEDs at 25mA of current with only 70mA of supply current at 12V. A high frequency switching regulator us used to reduce the power loss associated with multiple current dropping resistors.
Specifications

Power Requirements:
Operating Voltage: 10-18V DC
Operating Current: 70mA @ 12V DC (8 LEDs)
Current at low voltage shutoff point: 5mA

Theory

The heart of the circuit is a string of 8 white LEDs. These are wired in series and connected to a current-regulated step-up switching power supply circuit. The LM3578 switching regulator and its associated inductor, 1N5819 schottky diode, and 100uF 50V capacitor step the 12V power supply up to approximately 30V DC. The 10 ohm resistor on the cathode end of the LED string develops a voltage that is proportional to the current through the LEDs. This voltage is amplified by half of the LM358 op-amp and sends a negative feedback signal through a 4.7K resistor back to the LM3578. The 15K feedback resistor across the LM358 sets the LED series current, in this case, it is approximately 25mA.



Advertisement1


The other half of the LM358 (pins 1,2,3) is wired as a 10V voltage comparator. The 1N5242 zener diode and 10K series resistor produces a steady 5V on pin 2 of the LM358. The two 100K resistors on pin 3 of the LM358 divide the input voltage in half. If the supply voltage drops below 10V, the output of the LM358 drops, and pulls pin 2 of the LM3578 down through a 1N5819 schottky diode, causing the LM3578 to shut down. A schottky diode is used instead of a standard silicon diode in order for the LM3578 pin 2 voltage to go low enough to disable the circuit. Without the low voltage shutdown circuit, the LM3578 current will increase as the supply voltage decreases until the IC self-destructs.

The 2.2M resistor across the LM358 produces a hysteresis effect, the circuit turns off about .25V below where it turns back on, this prevents oscillation around the shutoff threshold. Below the low voltage cutoff point, the circuit will consume about 5mA of current.

An interesting characteristic of this circuit is that it acts as a negative resistance at the power supply terminals. As the supply voltage is increased, the current will drop. The total power consumption stays nearly even across changing input voltage conditions.

The heart of the circuit was inspired by F. Garcia’s IR LED video illumination circuit, published in the July 2001 edition of Nuts and Volts magazine. I modified the LED count and feedback circuit, and added the low voltage shutdown feature.

Visit Here for more.

 


Top