Browse over 10,000 Electronics Projects

100 MHz frequency source with selectable internal amplitude modulation

100 MHz frequency source with selectable internal amplitude modulation

The Saronix oscillator has an open emitter output. When the 330 Ohm load resistor on the output is grounded, the RF out of the oscillator increases. Modulation is affected by driving the MPSH34 on and off to switch the 330 Ohm load resistor.
An Atmel ATtiny12 provides a square wave signal that can be used to drive the MPSH34, or if the SPDT switch is in the other position, an external modulation source can be used to modulate the signal, or if nothing is connected to the modulation input, the RF output is at maximum value because of the two 10K pull-up resistors on the base of the MPSH34. This technique should work with an oscillator that requires an external pull-down resistor on its output.



Advertisement1


Visit Here for more.

 


Top