Browse over 10,000 Electronics Projects using the Page Numbering provided at the bottom of each Page.

PCB Router

PCB Router

Printed circuit boards are usually manufactured by chemical etching (with iron (III) chloride or ammonium persulfate, for example). This is not very practical if only a few boards are necessary, because these etchants are messy and somewhat dangerous.
My first design was a sort of bastard gantry mill. The workpiece was stationary; the spindle was bolted to the z-carriage, which travelled along the z-ways (grey), which were bolted to the y-carriage, which travelled along the y-ways (cyan), which were supported at either end by two x-carriages. Each carriage was driven by a screw; each screw was driven by a stepper motor, so that the x-motors were stationary, the y-motor moved in the x direction, and the z-motor moved in the x and y directions.



Advertisement


Visit Here for more.

 




Top